『上華 DSSS2.4G』
請問,上華原廠的2.4G(M11用),請問要如何設定(對頻)?還有這組2.4G有防爆走的功能嗎?要如何設定,謝謝

1.Turn the power switch to the ON position on the Transmitter.
The DSSS module LED will turn on after 6 seconds.
2.Depress and hold the DSSS Receiver binding button.
3.Turn the power switch to the ON position on the DSSS Receiver and continue holding the binding button.
4.The DSSS receiver LED will flash slowly.
5.Release the binding button on the DSSS Receiver after 2 seconds.
6.Depress and hold the binding button on the Transmitter until the LED on the DSSS receiver flashes rapidly.
7.Binding is now complete. Both DSSS module and Recevier LED will now stay on.
8.Operate the controls to confirm.

1.打開發射機電源 . DSSS模組LED在6秒以後將打開.
2.壓下並保持DSSS接收機按鈕.
3.打開DSSS接收機電源 並且 持續按住按鈕.
4.DSSS接收器LED將慢慢地閃動.
5.在2秒以後 放開DSSS接收器的按鈕。
6.壓下DSSS發射機模組按鈕,直到DSSS接收機LED快速閃動
7.DSSS接收機LED快速閃動完畢之後 LED將持續亮著
8.可以開始使用

1.Turn the power switch to the ON position on the Transmitter.Confirm DSSS Module LED is on.
2.Turn the power switch to the ON position on the DSSS Receiver.Confirm DSSS Receiver LED is on.
3.Move controls to confirm connection between Transmitter Receiver.
4.Move throttle lever to your desired Fail Safe position and hold.
Note:If the throttle lever is left in the neutral position,Fail Safe will be set at the position.
5.Depress the binding button on the DSSS Receiver for 4 secends.LED will flash slow.
6.Release the throttle lever after the receiver LED starts to flash rapidly.
7.Confirm that the Throttle Fail Safe is working properly by turning the Transmitter power switch off .
Turn the Transmitter power switch back on to confirm full control.

1.打開發射機電源 確定DSSS模組LED亮著
2.打開機收機電源 確定DSSS機收LED亮著
3.操作撥桿 確定 發射與機收可以正常工作
4.撥動油門桿在您希望防爆啟動的位置上 並且 保持住
注意:油門桿維持在中立位置,防爆啟動將被設在此位置
5.壓下DSSS接收器按鈕4秒.LED將慢慢閃動
6.在DSSS接收機LED快速閃動後 放開油門撥桿
7.關閉發射機 確定 防爆啟動時是否在設定的位置上
再打發射機 確定可以恢復控制

收到,多謝"ANGELZ"大大,謝謝