
|
![]() |
![]() | 頁碼:[ 1 2 ] ![]() |
『帖子主題』求救!!!!!JETI ADVANCE CAR SPORT 的... |
![]() 該內容引用 阿峰 在 2006/8/7 下午 12:56:40 發表的內容: 我頭痛ㄉ地方是 HI-POINT 跟 NATURE位置的設定 苦惱ㄚ 還是感謝WPJ大大您 發射機恆定ON, 第1步滿油門等5秒開車電、放開、關車電, 拔車電池,資料寫入韌體。 第2步滿煞車等5秒開車電、放開、關車電, 拔車電池,資料寫入韌體。 完成設定。 JETI設定要訣在於等5秒讓訊號恆定發送,拔車電池,資料寫入韌體。 還有無刷馬達3相電位、發射機油門設定反置測試, 很安全、有點複雜, 不過設定比較不會像NOVAK亂掉。 ![]() JETI的絕對優勢在於2年保固、大電流保護周到、過溫很難操壞、起步大紐力、堅固紮實........ 經濟、便宜、耐操、有檔頭! 「該帖子被 pcc0905 在 2006/8/7 下午 03:42:51 編輯過」 ![]() MSN:pcc0905@yahoo.com.tw | ||
|
![]() 該內容引用 阿峰 在 2006/8/7 下午 02:45:22 發表的內容: 還是搞不定耶 ㄧ直都嘟叫 我的MSN: pcc0905@yahoo.com.tw ![]() ![]() MSN:pcc0905@yahoo.com.tw | ||
|
![]() 該內容引用 阿峰 在 2006/8/7 下午 03:28:41 發表的內容: 謝謝大大: 晚上在等你的消息 拔車電池,資料寫入韌體。 ![]() MSN:pcc0905@yahoo.com.tw | ||
|
![]() Adjustment of the control range: -switch on the transmitter, push the throttle stick to full power position -switch on the controller switch (the drive battery and motor are connected, the JR connector is plugged into the motor throttle channel of the receiver) -5 seconds after switching on the controller switch there resound four beeps . . - . -return the throttle stick into neutral position -confirmation of the position storage in the memory is announced by one beep -switch off the controller switch, disconnect the drive battery -after 5 seconds connect up the drive battery again -adjust full brake (or full reverse drive) on the transmitter -switch on the controller switch (the drive battery and motor are connected up) -after 5 seconds there resound four beeps . . - . -shift the motor throttle stick to neutral position -confirmation of the position storage in the memory is announced by one beep This adjustment must be done only once and is permanently stored in the controller memory. Only when changing transmitters the procedure must be repeated. JETI寄來ㄌ 但還是搞不定 不知是哪裡弄錯ㄌ 各位大大幫各忙 謝謝啦 「該帖子被 阿峰 在 2006/8/7 下午 10:51:56 編輯過」 | ||
|
![]() 沒錯呀就是那個程序. 先開發射機,把油門固定最高全油門. 再開電變電源,等5秒,電變會有一小段音樂.. 音樂完成後,發射機回到中點,電變會逼一聲. 然後關掉電變電源,拔掉電變的電源線,因為電便上有電容要等一段時間約10sec.. 然後同樣程序再弄一變,只是換成殺車而已.. 祝你好運.. | ||
|
|